Panasonic DBS-576 Technical Manual page 402

FF3: Extension Programming
Notes:
Introduction
If this is set to 1=Ignore, the extension user will still be connected to the first call.
Related Programming:
0
System
Configuration
Trunk Key Operation: Brokers Hold
FF1
System
(all CPCs) - Version 1.0 or higher
Enable/Disable the Brokers Hold feature on a digital keyphone extension.
FF2
Trunks
FF3
Extensions
Notes:
FF4
FF-/Soft Keys
Brokers Hold: The ability to toggle between two calls on trunk keys by pressing HOLD.
If this address is set to 1=Enable Brokers Hold, the first call will be automatically retrieved when the
second call is put on hold.
FF5
If this address is left at the default 0=Disable Brokers Hold, the extension user will receive intercom
Groups
dial tone after putting the second call on hold (both calls will be on hold).
(the following applies only if Brokers Hold is left at default 0=Disable) If an appearance call (on an FF-
FF6 key) and a non-appearance call (on "EXT" LED/no FF-key) are both on hold...
TRS/ARS
the appearance call's FF-key will blink. Retrieve it by pressing the FF-key.
the "EXT" LED will blink for the non-appearance call. Retrieve it by pressing HOLD.
FF7
Related Programming:
Applications
FF8
Maintenance
Appendix A
Appendix B
Page 3-16
FF3 0 BSSC 04 15 Hold
BSSC: Extension Port
B=Cabinet no. 1-6
SS=Slot no. 01-12
C=Circuit no. 1-8
DBS 576 (USA) issued 05/20/98
Section 400-Programming
$ 
# 3 #$%
(0 or 1) Hold
0=Disable Brokers Hold. (default)
1=Enable Brokers Hold.
Introduction
0
System
Configuration
FF1
System
FF2
Trunks
FF3
Extensions
FF4
FF-/Soft Keys
FF5
Groups
FF6
TRS/ARS
FF7
Applications
FF8
Maintenance
Appendix A
Appendix B
576-13-400