Panasonic DBS-576 Technical Manual page 185

Section 400-Programming
Introduction
CO Busy Tone Detect Timer (Auto-Repeat Dial)
(all CPCs) - Version 1.0 or higher
Set the length of time the system will wait for a busy tone signal from the CO after the
0
Start Timer for CO Busy Tone Detect (Auto-Repeat Dial) (see previous address) has
System
Configuration
expired. This setting helps determine whether the next Auto-Repeat Dial will be performed.
FF1
System
FF2
Trunks
Notes:
FF3
Auto Repeat Dialing: Place a call to a busy party. Stay in monitor mode and press REDIAL. System
Extensions
automatically redials the number, and repeats redialing until ringback is heard or 14 auto-repeat
attempts have been made.
FF4
Related Programming:
FF-/Soft Keys
Flash Timer for Auto-Repeat Dial (pg. 1-117)
Start Timer for CO Busy Tone Detect (Auto-Repeat Dial) (pg. 1-122)
FF5
Groups
FF6
DTMF ON: Pattern #1
TRS/ARS
(all CPCs) - Version 1.0 or higher
Set the duration of the DTMF signal for a digit dialed during an outbound call.
FF7
Applications
FF8
Maintenance
Appendix A
Appendix B
576-13-400
FF1 1 01 0015 Hold (1-255) Hold
FF1 1 01 0016 Hold (1-255) Hold
(value=setting x 5ms):
DBS 576 (USA) issued 05/20/98
1=1 second
2=2 seconds
...
255=255 seconds (or 4 min./15 sec.)
default: 30 seconds
FF1 1 01 0003 Hold (1-255) Hold
FF1 1 01 0014 Hold (1-255) Hold
1 = (1 x 5 ms) = 5 ms
2 = (2 x 5 ms) = 10 ms
3 = (3 x 5 ms) = 15 ms
...
255 = (255 x 5 ms) = 1,275 ms (or 1.275 sec.)
default: 16 = (16 x 5 ms) = 80 ms
FF1: System Programming
/ 7% %
 
%2"  #) %
Page 1-123
Introduction
0
System
Configuration
FF1
System
FF2
Trunks
FF3
Extensions
FF4
FF-/Soft Keys
FF5
Groups
FF6
TRS/ARS
FF7
Applications
FF8
Maintenance
Appendix A
Appendix B