Panasonic DBS-576 Technical Manual page 336

FF2: Trunk Programming (T1 CO)
Related Programming:
Introduction
Disconnect Detect (pg. 2-88)
Dial Pulse Minimum Pause (pg. 2-88)
Ground Start Ring Type (pg. 2-89)
DID Ring Detect Timer (pg. 2-89)
0
Disconnect Supervision Timer (pg. 2-95)
System
Configuration
Guard Timer for Outbound Calls (pg. 2-96)
Inbound Ground Detect Timer (pg. 2-96)
FF1
System
Disconnect Detect
(all CPCs) - Version 1.0 or higher
FF2
Enable/Disable system detection of disconnect signal sent by the CO if the
Trunks
outside party disconnects first.
FF3
Extensions
FF4
FF-/Soft Keys
Notes:
This setting is available only if the Trunk Signal Type is set for "0" (Loop Start) or "1" (Ground Start);
FF5
it is not available for DID signaling types.
Groups
Related Programming:
Trunk Signal Type (pg. 2-87)
FF6
Disconnect Supervision Timer (pg. 2-95)
TRS/ARS
Dial Pulse Minimum Pause
FF7
Applications
(all CPCs) - Version 1.0 or higher
Set the minimum pause time for dial-pulse signaling.
FF8
Maintenance
Appendix A
Appendix B
Page 2-88
FF2 2 BSSCC 02 01 Hold (0 or 1) Hold
FF2 2 BSSCC 02 03 Hold (0 or 1) Hold
FF2 2 BSSCC 02 04 Hold (0 or 1) Hold
FF2 2 BSSCC
BSSCC: T1 (CO) Channel Position
B=Cabinet no. 1-6
SS=Slot no. 01-12
CC=Channel no. 01-24
FF2 2 BSSCC 02 00 Hold (0-3) Hold
FF2 2 BSSCC
BSSCC: T1 (CO) Channel Position
B=Cabinet no. 1-6
SS=Slot no. 01-12
CC=Channel no. 01-24
DBS 576 (USA) issued 05/20/98
FF2 2 BSSCC 02 02 Hold (0 or 1) Hold
FF2 2 BSSCC 02 12 Hold (0-3) Hold
FF2 2 BSSCC 02 13 Hold (0-3) Hold
FF2 2 BSSCC 02 14 Hold (0-3) Hold
02 01 Hold (0 or 1) Hold
0=No detection of disconnect signal
1=System will detect disconnect signal.
FF2 2 BSSCC 02 12 Hold (0-3) Hold
02 02 Hold (0 or 1) Hold
Section 400-Programming
$
 '
from CO. (default)
$
$ 2 )@$-
0=625 ms (default-US) or
750 ms (default-UK)
1=1000 ms
Introduction
0
System
Configuration
FF1
System
FF2
Trunks
FF3
Extensions
FF4
FF-/Soft Keys
FF5
Groups
FF6
TRS/ARS
FF7
Applications
FF8
Maintenance
Appendix A
Appendix B
576-13-400