Panasonic DBS-576 Technical Manual page 88

FF1: System Programming
Introduction
Step Calling: Intercom Calls
(all CPCs) - Version 1.0 or higher
Enable/Disable Step Calling for intercom calls.
0
System
Configuration
FF1
System
Notes:
FF2
Step Calling: After dialing one extension, the caller can dial the last digit of another extension to
Trunks
transfer himself to that extension.
If this address is set to "1" (Enable Step Calling) and step calling is performed during intercom busy
tone, the system will ring the dialed extension, and ignore any feature code that matches the dialed digit.
FF3
This means the following features cannot be dialed if Step Calling is enabled (however, they can be
Extensions
performed if they are already programmed into an FF-key):
2=Internal Camp-On
3=Extension Callback
FF4
4=Extension Message-Wait
FF-/Soft Keys
5=Priority Message-Wait
8=OHVA
9=Extension Busy Override
FF5
Groups
Related Programming:
FF6
TRS/ARS
Step Calling: DISA/Tie-Line
(all CPCs) - Version 1.0 or higher
FF7
Enable/Disable Step Calling for DISA or tie-line calls.
Applications
FF8
Maintenance
Notes:
Appendix A
Step Calling: After dialing one extension, the caller can dial the last digit of another extension to
transfer himself to that extension.
Appendix B
Page 1-26
FF1 0 02 0008 Hold (0 or 1) Hold
FF1 0 02 0009 Hold (0 or 1) Hold
0=Disable Step Calling for DISA and tie-line calls. (default)
1=Enable Step Calling for DISA and tie-line calls.
DBS 576 (USA) issued 05/20/98
0=Disable Step Calling for intercom calls. (default)
1=Enable Step Calling for intercom calls.
Section 400-Programming

*:% 6 ,,
&
% * 6 ,,
576-13-400
Introduction
0
System
Configuration
FF1
System
FF2
Trunks
FF3
Extensions
FF4
FF-/Soft Keys
FF5
Groups
FF6
TRS/ARS
FF7
Applications
FF8
Maintenance
Appendix A
Appendix B