Panasonic DBS-576 Technical Manual page 298

FF2: Trunk Programming (Analog E&M Tie)
Notes:
Introduction
Related Programming:
0
System SMDR Data to Serial Port (pg. 1-88)
Configuration
SMDR Output Format (pg. 1-93)
FF1
Flash Key Operation
System
(all CPCs) - Version 1.0 or higher
Set what happens when a digital phone user presses the FLASH, PROG or
Recall key during a call on this E&M tie trunk.
FF2
Trunks
FF3
BSSC: E&M Tie Trunk Position
Extensions
B=Cabinet no. 1-6
SS=Slot no. 01-12
C=Circuit no. 1-4
FF4
Notes:
FF-/Soft Keys
The sending of the flash signal can also be enabled/disabled on individual extensions (see Flash-Signal
Control on pg. 3-19).
FF5
If the flash signal is disabled on the trunk but enabled on the extension (or vice versa), a flash signal
Groups
will be sent when the user accesses the trunk and presses FLASH.
(all CPCs - Version 1.3 and higher)
also apply to an FF-key programmed for the SLT Flash Send feature (765 by default). See Dial Plans A
FF6
and B on pg. 1-155.
TRS/ARS
Related Programming:
Flash-Signal Control (pg. 3-19)
FF7
Dial Plan A: Flexible Feature Codes at Dial Tone (pg. 1-155)
Hold
Applications
Dial Plan B: Flexible Feature Codes at Dial Tone (pg. 1-157)
Hold
FF8
Maintenance
Appendix A
Appendix B
Page 2-50
FF1 0 06 0001 Hold (0-2) Hold
FF1 0 09 0001 Hold (0-2) Hold
FF2 0 BSSC 02 11 Hold (0 or 1) Hold
If this address is set to 0=Flash signal is sent to CO (default), it will
FF3 0 BSSC 04 21 Hold (0 or 1) Hold
DBS 576 (USA) issued 05/20/98
Section 400-Programming
",9 !!,
0=Flash signal is sent to CO. (default)
1=Trunk is released, then user hears
internal dial tone.
FF1 2 02 (0001-0056) Hold (max. 4-digit Code)
FF1 2 03 (0001-0056) Hold (max. 4-digit Code)
Introduction
0
System
Configuration
FF1
$
System
FF2
Trunks
FF3
Extensions
FF4
FF-/Soft Keys
FF5
Groups
FF6
TRS/ARS
FF7
Applications
FF8
Maintenance
Appendix A
Appendix B
576-13-400