Panasonic DBS-576 Technical Manual page 306

FF2: Trunk Programming (Analog E&M Tie)
Introduction
Trunk COS Assignment
(all CPCs) - Version 1.0 or higher
Assign a Trunk Class of Service (COS) to the E&M tie trunk.
0
System
Configuration
BSSC: E&M Tie Trunk Position
FF1
System
FF2
Notes:
Trunks
This Trunk COS Assignment controls the ring tone for incoming calls on this trunk - intercom ring
tone (2 short beeps followed by 3 seconds of silence), or a specific ring pattern. The Trunk COS also
controls various tie-line network settings. See FF1 0 04: Trunk COS Definitions (pg. 1-75).
FF3
Extensions
Related Programming:
Trunk COS: Incoming Ring Tone Source (pg. 1-75)
Trunk COS: Dial Tone to Tie-Line (pg. 1-76)
FF4
Trunk COS: Fast-Busy Tone to Tie-Line (pg. 1-77)
Trunk COS: Paging on DISA/Tie-Line Call (pg. 1-78)
FF-/Soft Keys
Ring Pattern (pg. 2-42)
FF5
Groups
Trunk Digital Pad Class Assignment
(all CPCs) - Version 1.0 or higher
FF6
Assign a Digital Pad Class to the E&M tie trunk.
TRS/ARS
FF7
Applications
FF8
Maintenance
Notes:
Based on this setting, you can assign automatic volume adjustments for different connection types to
this trunk (see FF1 8 02).
Appendix A
Related Programming:
Digital Pad Settings for Trunk Pad Class (pg. 1-178)
Appendix B
Page 2-58
FF2 0 BSSC
B=Cabinet no. 1-6
SS=Slot no. 01-12
C=Circuit no. 1-4
FF2 0 BSSC 01 12 Hold (0-12) Hold
FF2 0 BSSC
BSSC: E&M Tie Trunk Position
B=Cabinet no. 1-6
SS=Slot no. 01-12
C=Circuit no. 1-4
DBS 576 (USA) issued 05/20/98
07 Hold (1-16) Hold
Trunk Class of Service No. 1-16
default: 1
FF1 0 04 (00-15) 01 Hold (0 or 1) Hold
FF1 0 04 (00-15) 02 Hold (0 or 1) Hold
FF1 0 04 (00-15) 03 Hold (0 or 1) Hold
FF1 0 04 (00-15) 05 Hold (0 or 1) Hold
08 Hold (1-16) Hold
Trunk Digital Pad Class No. 1-16
default: 8
FF1 8 02 (0001-0480) Hold (0-31) Hold
Section 400-Programming
$ %
%-4 #
$  
%-4 $/ 5
576-13-400
Introduction
0
System
Configuration
FF1
System
FF2
Trunks
FF3
Extensions
FF4
FF-/Soft Keys
FF5
Groups
FF6
TRS/ARS
FF7
Applications
FF8
Maintenance
Appendix A
Appendix B