Panasonic DBS-576 Technical Manual page 147

Section 400-Programming
Introduction
RAI Serial Port: Maximum Input Digits
(all CPCs) - Version 1.0 or higher
Set the maximum number of digits that can be sent from the RAI serial port.
0
System
Configuration
FF1
System
Notes:
FF2
To use Remote Maintenance, set this address to "1" (digit).
Trunks
Related Programming:
FF3
Extensions
Serial Port 2: Data Format
FF4
FF-/Soft Keys
(all CPCs) - Version 1.0 or higher
Set data transmission format for Serial Port 2.
FF5
Groups
FF6
TRS/ARS
FF7
Applications
Notes:
FF8
Serial Port 2: The RS-232C connector labeled "CN6" on the SCC Card. A printer (for data output) or
Maintenance modem (for remote programming such as PCAS) can be connected to it.
If you use Serial Port 2, be sure to configure it here and in the FF1 0 06: Serial Port Output Data
addresses starting on pg. 1-88.
Related Programming:
Appendix A
SMDR Data to Serial Port (pg. 1-88)
Fault Alarm Data to Serial Port (pg. 1-88)
Appendix B
576-13-400
FF1 0 05 0021 Hold (1-255) Hold
FF1 0 05 0033 Hold (0-7) Hold
FF1 0 06 0001 Hold (0-2) Hold
DBS 576 (USA) issued 05/20/98
Maximum Number of Input Digits to RAI Serial Port
default: 1 (digit)
0 = 7 bits
-- even parity
1 = 7 bits -- odd parity
2 = 7 bits -- even parity
3 = 7 bits -- odd parity
4 = 8 bits -- no parity
5 = 8 bits -- no parity
6 = 8 bits -- even parity
7 = 8 bits -- odd parity
FF1 0 06 0002 Hold (0-2) Hold
FF1: System Programming
/   59
$   "!
-- 2 stop bits
-- 2 stop bits
-- 1 stop bit
-- 1 stop bit
-- 2 stop bits
-- 1 stop bit (default)
-- 1 stop bit
-- 1 stop bit
Page 1-85
Introduction
0
System
Configuration
FF1
System
FF2
Trunks
FF3
Extensions
FF4
FF-/Soft Keys
FF5
Groups
FF6
TRS/ARS
FF7
Applications
FF8
Maintenance
Appendix A
Appendix B