Panasonic DBS-576 Technical Manual page 258

FF2: Trunk Programming (Analog CO)
Introduction
Ground Start Ring Type
(all CPCs) - Version 1.0 or higher
Set whether the CO supplies the real ringing signal. Applies to Ground-Start
0
trunks, which typically need Tip-Ground for incoming signal.
System
Configuration
FF1
System
BSSC: Analog (CO) Trunk Position
B=Cabinet no. 1-6
SS=Slot no. 01-12
FF2
C=Circuit no. 1-8
Trunks
Notes:
FF3
Extensions
Related Programming:
Trunk Signal Type (pg. 2-8)
FF4
FF-/Soft Keys
DID Ring Detect Timer
(all CPCs) - Version 1.0 or higher
FF5
Set the DID Ring Detect timer, which will be used to specify the ringing.
Groups
FF6
TRS/ARS
BSSC: Analog (CO) Trunk Position
FF7
Applications
Notes:
If CO is set to Immediate Start, system will wait this long before recognizing ring from CO.
FF8
Maintenance
This setting is available only if the Trunk Signal Type is set for "2" (DID Immediate Start) or "3" (DID
Wink Start); it is not available for Loop Start or Ground Start signaling types.
Related Programming:
Trunk Signal Type (pg. 2-8)
Appendix A
Appendix B
Page 2-10
FF2 0 BSSC
FF2 0 BSSC 01 00 Hold (0-3) Hold
FF2 0 BSSC
B=Cabinet no. 1-6
SS=Slot no. 01-12
C=Circuit no. 1-8
FF2 0 BSSC 01 00 Hold (0-3) Hold
DBS 576 (USA) issued 05/20/98
01 04 Hold (0 or 1) Hold
0=Ringing signal (default)
1=No ringing signal
01 05 Hold (0 or 1) Hold
0=32 ms (default)
1=96 ms
Section 400-Programming
$ 
1  %6
$
 *% %
576-13-400
Introduction
0
System
Configuration
FF1
System
FF2
Trunks
FF3
Extensions
FF4
FF-/Soft Keys
FF5
Groups
FF6
TRS/ARS
FF7
Applications
FF8
Maintenance
Appendix A
Appendix B