Table of Contents
Advertisement
Figure 4-8
Step 2: Switch on your PC and start the terminal software
Set the following terminal software parameters: 9600, 8, no parity, no
flow control.
Step 3: Configure M11 using CLI commands
In configurations given here, we assume that the unit uses its default
configurations and the changes are done on top of the default
configuration.
The Nokia M11 command line interface includes a step mode to
automate the process of entering configuration settings. When you use
the Config step mode, the CLI prompts you for all required and
optional information. You can enter the configuration values
appropriate for your site without having to enter complete CLI
commands.
To enter the Config step mode, type
Config hierarchy.
When you are in step mode, the CLI prompts you to enter the required
and optional settings. If a setting has a default value or a current
setting, the command line interface displays the default value for the
command in parentheses. If a command has a limited number of
acceptable values, those values are presented in brackets, with each
value separated by a vertical line. For example, the following CLI step
C33833001SE_00
DSR DCD RTS CTS
Node Manager Connector
(RJ 45)
1
8
Location of the console port
E Copyright Nokia Networks Oy
Installing M11
OK EXIT
DNT2M
1. 107 (Const. ON)
2. 108 (IN)
3. 109 (OUT)
4. SG
5. 103 (IN)
6. 104 (OUT)
7. 105 (IN)
8. 106 (OUT)
from the top node of the
set
4-17
Advertisement
Table of Contents
