To Set Aux Output - Teledyne T3DSO2000 Series User Manual

To Set Aux Output

Users can set the type of the signal output from the [Trigger Out] connector at the rear
panel.
1. Press the Utility button on the front panel to enter the UTILITY function menu.
2. Press the I/O Set softkey to enter the I/O SET function menu.
3. Press the Aux Output softkey to select Trig Out or Pass/Fail. The default setup is Trig
Out.
�
�
1.800.561.8187
Trig Out: If this type is selected, the oscilloscope outputs a signal that can reflect
the current capture rate of the oscilloscope at each trigger. The maximal capture
rate of T3DSO2000 is 140k wfs/s.
Pass/Fail: If this type is selected, the oscilloscope will output a pulse signal when
failed waveforms are detected. This signal can be connected to other control
systems to conveniently view the test results.
www.
information@itm.com
.com
169