Aux Output - Teledyne LabMaster 10 Zi Series Getting Started Manual

Aux Output

The Aux Output dialog allows you to specify Auxiliary and Calibration
Output details.
1.
If you want a specialized output, touch one of the following buttons
under Use Auxiliary Output For: Square Wave, Trigger Enabled,
Trigger Out, Pass/Fail, or Off.
NOTE Pass/Fail
: If
the dialog, a
value within your instrument's specified range. Refer to datasheet
specifications at www.teledynelecroy.com.
2.
On the Use Calibration Output For section of the dialog, choose
Square, DC Level, or Off. If you want a 1 kHz, 1 V Square Wave, touch
the Set to 1 kHz, 1 V Square Wave button.
3.
If Square or DC Level is selected, enter these additional values:

If you selected Square, enter a Frequency .

If you selected Square or DC Level, enter an Amplitude into 1
MΩ.
922561-00 Rev A
is selected on this
Pulse Duration
data entry control is made available. Provide a
Getting Started Manual
Use Auxiliary Output For
section of
155