Zeroconf - Mellanox Technologies Mellanox SX1018 Command Reference Manual

zeroconf

zeroconf
no zeroconf
Enables zeroconf on the specified interface. It randomly chooses a unique link-local
IPv4 address from the 169.254.0.0/16 block. This command is an alternative to
DHCP.
The no form of the command disables the use of zeroconf on the specified interface.
Syntax Description N/A
Default no zeroconf
Modes/Context Config Interface Management
History 3.1.0000
Role admin
Example
switch (config interface mgmt0) # zeroconf
switch (config) # show interfaces mgmt0 configured
Interface mgmt0 configuration
Related Commands show interfaces <ifname> configured
Note Enabling zeroconf disables DHCP and vice versa.
Enabled: yes
DHCP: no
Zeroconf: yes
IP address:
Netmask:
IPv6 enabled: yes
Autoconf enabled: no
Autoconf route: yes
Autoconf privacy: no
IPv6 addresses: 0
Speed: auto
Duplex: auto
MTU: 1500
Comment:
Mellanox Technologies
Rev 1.6.2
35