Table 8 Configuration Wizard Session - Zeroconf Configuration - Mellanox Technologies Mellanox SX1018 User Manual

Rev 1.0
Table 8 - Configuration Wizard Session - Zeroconf Configuration
Mellanox configuration wizard
Do you want to use the wizard for initial configuration? yes
Step 1: Hostname? [switch]
Step 2: Use DHCP on mgmt0 interface? [yes] no
Step 3: Use zeroconf on mgmt0 interface? [no] yes
Step 4: Default gateway? [For example:192.168.10.1]
Step 5: Primary DNS server?
Step 6: Domain name?
Step 7: Enable IPv6? [yes]
Step 8: Enable IPv6 autoconfig (SLAAC) on mgmt0 interface? [no]
Step 9: Admin password (Enter to leave unchanged)?
To change an answer, enter the step number to return to.
Otherwise hit <enter> to save changes and exit.
Choice:
Configuration changes saved.
To return to the wizard from the CLI, enter the "configuration jump-start"
command from configure mode. Launching CLI...
switch>
Before attempting a remote (for example, SSH) connection to the switch, check the mgmt0
Step 6.
interface configuration. Specifically, verify the existence of an IP address. To check the current
mgmt0 configuration, enter the following commands:
switch > enable
switch # configure terminal
switch (config)# show interfaces mgmt0
The following is an example of the output:
Interface mgmt0 state
20 Mellanox Technologies
Wizard Session Display - IP Zeroconf Configuration (Example)
Admin up:
Link up:
IP address:
Netmask:
Speed:
Duplex:
Interface type:
yes
yes
192.168.10.4
255.255.255.0
1000Mb/s (auto)
full (auto)
ethernet
Configuring the Switch the First Time