Alias - Mellanox Technologies Mellanox SX1018 Command Reference Manual

alias

alias <index> ip address < IP address> <netmask>
no alias <index>
Adds an additional IP address to the specified interface. The secondary address will
appear in the output of "show interface" under the data of the primary interface along
with the alias.
The no form of the command removes the secondary address to the specified inter-
face.
Syntax Description index
IP address
netmask
Default N/A
Modes/Context Config Interface Management
History 3.1.0000
Role admin
Example
switch (config interface mgmt0) # alias 2 ip address 9.9.9.9
255.255.255.255
switch (config interface mgmt0) # show interfaces mgmt0
Interface mgmt0 state
switch (config interface mgmt0) #
Admin up: yes
Link up: yes
IP address: 172.30.2.2
Netmask: 255.255.0.0
Secondary address: 9.9.9.9/32 (alias: 'mgmt0:2')
IPv6 enabled: yes
Autoconf enabled: no
Autoconf route: yes
Autoconf privacy: no
IPv6 addresses: 1
IPv6 address: fe80::202:c9ff:fe5e:a5d8/64
Speed: 1000Mb/s (auto)
Duplex: full (auto)
Interface type: ethernet
Interface ifindex: 2
Interface source: physical
MTU: 1500
HW address: 00:02:C9:5E:A5:D8
Comment:
RX bytes: 2970074221
RX packets: 44983023
RX mcast packets: 0
RX discards: 0
RX errors: 0
RX overruns: 0
RX frame: 0
A number that is to be aliased to (associated with) the
secondary IP.
Additional IP address.
Subnet mask of the IP address.
TX bytes:
TX packets:
TX discards:
TX errors:
TX overruns:
TX carrier:
TX collisions:
TX queue len:
Mellanox Technologies
Rev 1.6.2
468579522
1390539
0
0
0
0
0
1000
26