Show Ip/Ipv6 Default-Gateway; Ip Arp - Mellanox Technologies Mellanox SX1018 Command Reference Manual

show ip/ipv6 default-gateway

Syntax Description
Default
Modes/Context
History
Role
Example
Related Commands
Note
2.1.4 Network to Media Resolution (ARP & NDP)
IPv4 network use Address Resolution Protocol (ARP) to resolve IP address to MAC address,
while IPv6 network uses Network Discovery Protocol (NDP) that performs basically the same as
ARP.

ip arp

Syntax Description
Default
Modes/Context
History
Role
show {ip | ipv6} default-gateway [static]
Displays the default gateway.
static
N/A
Any Command Mode
3.1.0000
admin
switch (config) # ip default-gateway 10.10.10.10
switch (config) # show ip default-gateway
Active default gateways:
172.30.0.1 (interface: mgmt0)
switch (config) # show ip default-gateway static
Configured default gateway: 10.10.10.10
show ip default-gateway
The configured IPv4 default gateway will not be used if DHCP is enabled.
ip arp <IP address> <MAC address>
no ip arp <IP address> <MAC address>
Sets a static ARP entry.
The no form of the command deletes the static ARP.
IP address
MAC address
N/A
Config Interface Management
3.2.0500
admin
Displays the static configuration of the default gateway.
IPv4 address.
MAC address.
Mellanox Technologies
Rev 1.6.2
52