Mtu - Mellanox Technologies Mellanox SX1018 Command Reference Manual

mtu

mtu <bytes>
no mtu <bytes>
Sets the Maximum Transmission Unit (MTU) of this interface.
The no form of the command resets the MTU to its default.
Syntax Description bytes
Default 1500
Modes/Context Config Interface Management
History 3.1.0000
Role admin
Example
switch (config interface mgmt0) # mtu 1500
switch (config interface mgmt0) # show interfaces mgmt0
Interface mgmt0 state
switch (config interface mgmt0) #
Related Commands show interfaces <ifname>
Note
Admin up: yes
Link up: yes
IP address: 172.30.2.2
Netmask: 255.255.0.0
Secondary address: 9.9.9.9/32 (alias: 'mgmt0:2')
IPv6 enabled: yes
Autoconf enabled: no
Autoconf route: yes
Autoconf privacy: no
IPv6 addresses: 1
IPv6 address: fe80::202:c9ff:fe5e:a5d8/64
Speed: 1000Mb/s (auto)
Duplex: full (auto)
Interface type: ethernet
Interface ifindex: 2
Interface source: physical
MTU: 1500
HW address: 00:02:C9:5E:A5:D8
Comment:
RX bytes: 2970074221
RX packets: 44983023
RX mcast packets: 0
RX discards: 0
RX errors: 0
RX overruns: 0
RX frame: 0
The entry range is 68-1500.
TX bytes:
TX packets:
TX discards:
TX errors:
TX overruns:
TX carrier:
TX collisions:
TX queue len:
Mellanox Technologies
Rev 1.6.2
468579522
1390539
0
0
0
0
0
1000
28