Channel-Group - Mellanox Technologies Mellanox SX1018 Command Reference Manual

channel-group

channel-group <1-4096> [mode {on | active | passive}]
no channel-group
Assigns and configures a physical interface to a port channel.
The no form of the command removes a physical interface from the port-channel.
Syntax Description 1-4096
mode on
mode active/passive
Default N/A
Modes/Context Config interface ethernet
History 3.1.1400
Role admin
Example
switch (config interface 1/7)# channel-group 1 mode active
switch (config interface 1/7)# show interfaces port-channel summary
Flags: D- Down P - Up in port-channel (members)
I - Individual H - Hot-standby (LACP only)
s - Suspended r - Module-removed
U - Up (port-channel)
----------------------------------------------------------------------
Group Port-
Channel
---------------------------------------------------------------------
1 Po1(D)
switch (config interface 1/7)#
Related Commands show interfaces port-channel summary
show interfaces port-channel compatibility-parameters
show lacp interfaces ethernet
Note
•
•
•
Type
LACP
Setting the mode to active/passive is possible only in LACP is enabled.
The first port in the LAG decide if the LAG will be static ("on") or LACP ("active" ,
"pasive").
All the ports in the LAG must have the same configuration, determines by the first port
added to the LAG. The port with a different configuration will be rejected, for the list of
dependencies refer to 'show interfaces port-channel compatibility-parameters'
The port channel number.
Static assignment the port to LAG. LACP will not be
enabled on this port.
Dynamic assignment of the port to LAG. LACP will be
enabled in either passive or active mode.
Member Ports
Eth1/7(D)
Mellanox Technologies
Rev 1.6.2
315