Image Install - Mellanox Technologies Mellanox SX1018 Command Reference Manual

image install

image install <image filename> [location <location ID>] | [progress <prog-
options>] [verify <ver-options>]
Installs the specified image file.
Syntax Description image filename
location ID
prog-options
ver-options
Default N/A
Modes/Context Config
History 3.1.0000
Role admin
Example
switch (config) # image install SX_PPC_M460EX 3.0.0000-dev-HA 2012-01-
22 08:47:59 ppc
Step 1 of 4: Verify Image
100.0%
[################################################################]
Step 2 of 4: Uncompress Image
100.0%
[################################################################]
Step 3 of 4: Create Filesystems
100.0%
[################################################################]
Step 4 of 4: Extract Image
100.0%
[################################################################]
switch (config) #
Related Commands show images
Note •
•
The image cannot be installed on the "active" location (the one which is currently being
booted)
On a two-location system, the location is chosen automatically if no location is specified
Specifies the image name.
Specifies the image destination location.
• "no-track" overrides CLI default and does not track the
installation progress
• "track" overrides CLI default and tracks the installation
progress
• "check-sig" requires an image to have either a valid sig-
nature or no signature
• "ignore-sig" allows unsigned or invalidly signed images
to be installed
• "require-sig" requires from the installed image to have a
valid signature. If a valid signature is not found on the
image, the image cannot be installed.
Mellanox Technologies
Rev 1.6.2
80