2.4 Software Management; Image Boot - Mellanox Technologies Mellanox SX1018 Command Reference Manual

2.4 Software Management

This chapter displays all the relevant commands used to manage the system software image.

image boot

Syntax Description
Default
Modes/Context
History
Role
Example
Related Commands
Note
image boot {location <location ID> | next}
Specifies the default location where the system should be booted from.
location ID
next
N/A
enable/config
3.1.0000
admin
switch (config) # image boot location 2
switch (config) #
show images
Specifies the default destination location. There can be
up to 2 images on the system. The possible values are 1
or 2.
Sets the boot location to be the next once after the one
currently booted from, thus avoiding a cycle through all
the available locations.
Mellanox Technologies
Rev 1.6.2
75