Power Meter And Sensor Capability - Agilent Technologies N1911A User Manual

Power Meter and Sensor Capability

Your P- Series power meter is compatible with Agilent P- Series, E- Series
E9320, E- Series E9300, E- Series E4410, 8480 Series and the N8480 Series
power sensors. However, not all sensor and meter combinations have the
same features or capabilities. The main differences are as below:
Features
Average power of CW signal
Average power of modulated signal
Peak power
Cal factors stored on EEPROM
>200 readings/sec
Peak/burst average power
Time gated measurements
Rising edge trigger
Falling edge trigger
• The E-Series, 8480 Series and N8480 Series power sensors require N1917A/B/C cables
N O T E
• The N8480 Series power sensors used in this user's guide is refering to all sensors from
Specifications
The specifications for the power meter are listed in
"Specifications and Characteristics," starting on page 253.
N1911A/1912A P-Series Power Meters User's Guide
P-Series
N1920
•
•
•
•
•
•
•
•
•
1
Not applicable for N8480 Series power sensors with Option CFT
when connected to the P-Series power meters.
the N8480 Series unless otherwise stated.
E-Series E-Series
E9320 E9300
• •
• •
•
• •
• •
•
•
•
•
Introduction
E-Series 8480
E4410 Series
• •
•
•
•
Chapter 11,
1
N8480
Series
•
•
1
•
3