Figure 1-5 Trace Display In Single Enlarged Window In Markers Mode - Agilent Technologies N1911A User Manual

Figure 1-5 Trace display in single enlarged window in markers mode

Figure 1- 5
associated tables and markers. The Gate Control is the default display
when using trace display.
24 Pressing
25 The markers, 1 and 2, indicate the start and end points of the selected
26 The highlighted table, with the green border, shows the time (Time:) and
Gate timing parameters are all related to your chosen trigger point. This may be different
N O T E
from the timing of the triggering event if you have configured a trigger delay. Refer to item
No 30 for more information.
27 This table shows the time (Time:) and the instantaneous power level
28 The highlighted marker shows the active marker at the configured point.
29 This table shows the width of the gate
N1911A/1912A P-Series Power Meters User's Guide
28
26
27
shows a single enlarged window with the Gate Ctrl menu and
Gate
scrolls through the 4 gates available for each channel.
Marker
gate. Pressing
and keys to move the active marker along the trace.
the instantaneous power level (Pow:) of the active marker at the
configured point. A negative time value indicates a measurement before
the trigger point.
(Pow:) of the inactive marker at the configured point.
the average, peak, and peak- to- average ratio power measurements
within the active gate.
toggles between the two markers. You can use the
Δ
Introduction
24
25
29
T: (time between the markers),
1
15