7
Using 8480 Series Power Sensors
Does this setting match the value for the sensor? (The power sensor
reference calibration factor can normally be found above the calibration
factors table on the power sensor body.)
10 To change the settings, use the
Figure 7-126Calibration factor pop-up window
11 Press
12 Connect the power sensor to the signal to be measured.
13 The corrected measurement result is displayed.
Figure 7-127Calibration factor display
182
value field and press
numeric keypad to enter the required value in the Cal Factor pop- up
window.
%
to complete the entry.
and
keys to highlight the Cal Fac
to display the Cal Factor pop- up. Use the
N1911A/1912A P-Series Power Meters User's Guide
Calibration Factor