Figure 2-60 Sensor Mode Pop-Up - Agilent Technologies N1911A User Manual

When E-Series E9320 or P-Series N1920 sensor is connected, the default sensor mode is
N O T E
Normal. User can use this Normal mode to perform power or frequency sweep, or change
the mode to AVG only to perform power or frequency sweep. Refer
differences in measurement functions supported under these two modes.
To change the sensor mode from the default Normal mode to AVG only mode, follow the
instructions below:
• Press
• Press
• Use the
4 Press
5 Press
6 Select either
N1911A/1912A P-Series Power Meters User's Guide
. Use the
to display the Sensor Mode pop-up.

Figure 2-60 Sensor Mode pop-up.

and keys to highlight the AVG and press
. The Trigger menu is displayed.
Acqn
softkey to configure the trigger.
Sing Trig
Sing Trig
• is a single shot mode. After triggering, the measurement is
halted, and the
measurement by pressing the
Cont Trig
• is a continuos trigger mode. The symbol
displayed.
General Power Meter Functions
and keys to highlight the Sensor Mode field.
Cont Trig
or .
symbol is displayed. You can start another
Table 2-6 on the
.
key.
or is
2
75