Configure Bfd For Is-Is - Dell S6100 Configuration Manual

Disabling BFD for OSPFv3
If you disable BFD globally, all sessions are torn down and sessions on the remote system are placed in a Down state.
If you disable BFD on an interface, sessions on the interface are torn down and sessions on the remote system are placed in a Down state.
Disabling BFD does not trigger a change in BFD clients; a final Admin Down packet is sent before the session is terminated.
To disable BFD sessions, use the following commands.
• Disable BFD sessions with all OSPFv3 neighbors.
ROUTER-OSPFv3 mode
no bfd all-neighbors
• Disable BFD sessions with OSPFv3 neighbors on a single interface.
INTERFACE mode
ipv6 ospf bfd all-neighbors disable

Configure BFD for IS-IS

When using BFD with IS-IS, the IS-IS protocol registers with the BFD manager on the RPM. BFD sessions are then established with all
neighboring interfaces participating in IS-IS. If a neighboring interface fails, the BFD agent on the line card notifies the BFD manager, which
in turn notifies the IS-IS protocol that a link state change occurred.
Configuring BFD for IS-IS is a two-step process:
1 Enable BFD globally.
2 Establish sessions for all or particular IS-IS neighbors.
Related Configuration Tasks
• Changing IS-IS Session Parameters
• Disabling BFD for IS-IS
Bidirectional Forwarding Detection (BFD) 149