Vrrp Example; Configuration Examples - Dell PowerConnect B-FCXs Configuration Manual

PowerConnect#show process cpu 2
Statistics for last 1 sec and 80 ms
Process Name
ARP
BGP
GVRP
ICMP
IP
OSPF
RIP
STP
VRRP
When you specify how many seconds' worth of statistics you want to display, the software selects
the sample that most closely matches the number of seconds you specified. In this example,
statistics are requested for the previous two seconds. The closest sample available is actually for
the previous 1 second plus 80 milliseconds.
Syntax: show process cpu [<num>]
The <num> parameter specifies the number of seconds and can be from 1 – 900. If you use this
parameter, the command lists the usage statistics only for the specified number of seconds. If you
do not use this parameter, the command lists the usage statistics for the previous one-second,
one-minute, five-minute, and fifteen-minute intervals.

Configuration examples

The following sections contain the CLI commands for implementing the VRRP and VRRPE
configurations shown in

VRRP example

To implement the VRRP configuration shown in
method.
Configuring Router1
To configure VRRP Router1, enter the following commands.
Router1(config)#router vrrp
Router1(config)#inter e 1/6
Router1(config-if-1/6)#ip address 192.53.5.1
Router1(config-if-1/6)#ip vrrp vrid 1
Router1(config-if-1/6-vrid-1)#owner track-priority 20
Router1(config-if-1/6-vrid-1)#track-port ethernet 2/4
Router1(config-if-1/6-vrid-1)#ip-address 192.53.5.1
Router1(config-if-1/6-vrid-1)#activate
NOTE
When you configure the Master (Owner), the address you enter with the ip-address command must
already be configured on the interface.
PowerConnect B-Series FCX Configuration Guide
53-1002266-01
Sec(%) Time(ms)
0.00 0
0.00 0
0.00 0
0.01 1
0.00 0
0.00 0
0.00 0
0.01 0
0.00 0
Figure 151 on page 1103 and
Configuration examples
Figure 152 on page 1108.
Figure 151 on page 1103, use the following
31
1131