Enabling Tacacs; Identifying The Tacacs/Tacacs+ Servers - Dell PowerConnect B-FCXs Configuration Manual

32
Configuring TACACS/TACACS+ security
•
TACACS configuration procedure
Follow the procedure given below for TACACS configurations.
1. Identify TACACS servers. Refer to
2. Set optional parameters. Refer to
3. Configure authentication-method lists. Refer to
TACACS+ configuration procedure
Follow the procedure given below for TACACS+ configurations.
1. Identify TACACS+ servers. Refer to
2. Set optional parameters. Refer to
3. Configure authentication-method lists. Refer to
4. Optionally configure TACACS+ authorization. Refer to
5. Optionally configure TACACS+ accounting. Refer to

Enabling TACACS

TACACS is disabled by default. To configure TACACS/TACACS+ authentication parameters, you must
enable TACACS by entering the following command.
PowerConnect(config)#enable snmp config-tacacs
Syntax: [no] enable snmp <config-radius | config-tacacs>
The <config-radius> parameter specifies the RADIUS configuration mode. RADIUS is disabled by
default.
The <config-tacacs> parameter specifies the TACACS configuration mode. TACACS is disabled by
default.

Identifying the TACACS/TACACS+ servers

To use TACACS/TACACS+ servers to authenticate access to a Dell PowerConnect device, you must
identify the servers to the Dell PowerConnect device.
For example, to identify three TACACS/TACACS+ servers, enter commands such as the following.
PowerConnect(config)#tacacs-server host 207.94.6.161
PowerConnect(config)#tacacs-server host 207.94.6.191
PowerConnect(config)#tacacs-server host 207.94.6.122
1170
You can configure the Dell PowerConnect device to authenticate using a TACACS or TACACS+
server, not both.
page 1172.
TACACS/TACACS+" on page 1173.
page 1172.
TACACS/TACACS+" on page 1173.
page 1175.
page 1178.
"Identifying the TACACS/TACACS+ servers"
"Setting optional TACACS/TACACS+ parameters"
"Configuring authentication-method lists for
"Identifying the TACACS/TACACS+ servers"
"Setting optional TACACS/TACACS+ parameters"
"Configuring authentication-method lists for
"Configuring TACACS+ authorization"
"Configuring TACACS+ accounting"
PowerConnect B-Series FCX Configuration Guide
on page 1170.
on
on page 1170.
on
on
on
53-1002266-01