Displaying The Active Bgp4 Configuration; Displaying Cpu Utilization Statistics - Dell PowerConnect B-FCXs Configuration Manual

30
Displaying BGP4 information
TABLE 184
Field
Filtered
Sent
ToSend

Displaying the active BGP4 configuration

To view the active BGP4 configuration information contained in the running-config without
displaying the entire running-config, use the following CLI method.
To display the device active BGP4 configuration, enter the following command at any level of the
CLI.
PowerConnect#show ip bgp config
Current BGP configuration:
router bgp
address-filter
as-path-filter
local-as 65002
maximum-paths 4
neighbor pg1 peer-group
neighbor pg1 remote-as 65001
neighbor pg1 description "PowerConnect group 1"
neighbor pg1 distribute-list out 1
neighbor 192.169.100.1 peer-group pg1
neighbor 192.169.101.1 peer-group pg1
neighbor 192.169.102.1 peer-group pg1
neighbor 192.169.201.1 remote-as 65101
neighbor 192.169.201.1 shutdown
neighbor 192.169.220.3 remote-as 65432
network 1.1.1.0 255.255.255.0
network 2.2.2.0 255.255.255.0
redistribute connected
Syntax: show ip bgp config

Displaying CPU utilization statistics

You can display CPU utilization statistics for BGP4 and other IP protocols.
To display CPU utilization statistics for BGP4 for the previous one-second, one-minute, five-minute,
and fifteen-minute intervals, enter the following command at any level of the CLI.
1064
BGP4 summary information (Continued)
Description
The routes or prefixes that have been filtered out:
•
If soft reconfiguration is enabled, this field shows how many routes were
filtered out (not placed in the BGP4 route table) but retained in memory.
•
If soft reconfiguration is not enabled, this field shows the number of BGP4
routes that have been filtered out.
The number of BGP4 routes that the Layer 3 Switch has sent to the neighbor.
The number of routes the Layer 3 Switch has queued to send to this neighbor.
1 deny any any
1 permit ^65001$
PowerConnect B-Series FCX Configuration Guide
53-1002266-01