Dell PowerConnect B-FCXs Configuration Manual page 1296

34
Displaying 802.1X information
The all keyword displays all dynamically applied IP ACLs active on the device.
Specify the <port> variable in the following formats:
•
Displaying the status of strict security mode
The output of the show dot1x and show dot1x config commands indicate whether strict security
mode is enabled or disabled globally and on an interface.
Displaying the status of strict security mode globally on the device
To display the status of strict security mode globally on the device, enter the following command.
PowerConnect#show dot1x
PAE Capability:
system-auth-control: Enable
re-authentication: Disable
global-filter-strict-security: Enable
quiet-period:
tx-period:
supptimeout:
servertimeout:
maxreq:
re-authperiod:
security-hold-time: 60 Seconds
Protocol Version:
Syntax: show dot1x
Displaying the status of strict security mode on an interface
To display the status of strict security mode on an interface, enter a command such as the following
PowerConnect#show dot1x config e 1/3
Port 1/3 Configuration:
Authenticator PAE state:
Backend Authentication state:
AdminControlledDirections:
OperControlledDirections:
AuthControlledPortControl:
AuthControlledPortStatus:
quiet-period:
tx-period:
supptimeout:
servertimeout:
maxreq:
re-authperiod:
security-hold-time: 60 Seconds
re-authentication: Disable
multiple-hosts: Disable
filter-strict-security: Enable
Protocol Version:
Syntax: show dot1x config ethernet <port>
Specify the <port> variable in the following formats:
1254
PowerConnect B-Series FCX stackable switches – <stack-unit/slotnum/portnum>
Authenticator Only
60 Seconds
30 Seconds
30 Seconds
30 Seconds
2
3600 Seconds
1
60 Seconds
30 Seconds
30 Seconds
30 Seconds
2
3600 Seconds
1
AUTHENTICATED
IDLE
BOTH
BOTH
Auto
authorized
PowerConnect B-Series FCX Configuration Guide
53-1002266-01