Dell PowerConnect B-FCXs Configuration Manual page 1291

PowerConnect#show dot1x configuration ethernet 1/3
Port-Control
filter strict security
Action on RADIUS timeout
re-authenticate
PVID State
Original PVID
PVID mac total
PVID mac authorized
num mac sessions
num mac authorized
Number of Auth filter
Syntax: show dot1x config ethernet <port>
Specify the <port> variable in the following formats:
•
The following additional information is displayed in the show dot1x config command for an
interface.
TABLE 213
This field...
Authenticator PAE state
Backend Authentication state
AdminControlledDirections
OperControlledDirections
AuthControlledPortControl
PowerConnect B-Series FCX Configuration Guide
53-1002266-01
PowerConnect B-Series FCX stackable switches – <stack-unit/slotnum/portnum>
Output from the show dot1x config command for an interface
Displaying 802.1X information
: control-auto
: Enable
: Treat as a failed authentication
: 150 seconds
: Normal (101)
: 101
: 1
: 1
: 1
: 1
: 0
Displays...
The current status of the Authenticator PAE state machine. This
can be INITIALIZE, DISCONNECTED, CONNECTING,
AUTHENTICATING, AUTHENTICATED, ABORTING, HELD,
FORCE_AUTH, or FORCE_UNAUTH.
NOTE: When the Authenticator PAE state machine is in the
AUTHENTICATING state, if the reAuthenticate, eapStart,
eapLogoff, or authTimeout parameters are set to TRUE, it
may place the Authenticator PAE state machine indefinitely
in the ABORTING state. If this should happen, use the dot1x
initialize command to initialize 802.1X port security on the
port, or unplug the Client or hub connected to the port, then
reconnect it.
The current status of the Backend Authentication state machine.
This can be REQUEST, RESPONSE, SUCCESS, FAIL, TIMEOUT, IDLE,
or INITIALIZE.
Indicates whether an unauthorized controlled port exerts control
over communication in both directions (disabling both reception of
incoming frames and transmission of outgoing frames), or just in
the incoming direction (disabling only reception of incoming
frames). On Powerconnect devices, this parameter is set to BOTH.
The setting for the OperControlledDirections parameter, as defined
in the 802.1X standard. According to the 802.1X standard, if the
AdminControlledDirections parameter is set to BOTH, the
OperControlledDirections parameter is unconditionally set to BOTH.
Since the AdminControlledDirections parameter on Dell
PowerConnect devices is always set to BOTH, the
OperControlledDirections parameter is also set to BOTH.
The port control type configured for the interface. If set to auto,
authentication is activated on the 802.1X-enabled interface.
34
1249