Dell PowerConnect B-FCXs Configuration Manual page 742

Powerconnect b-series fcx
Hide thumbs Also See for PowerConnect B-FCXs:
Table of Contents

Advertisement

24
Configuring LLDP
802.1 capabilities:
802.3 capabilities:
The above TLVs are described in detail in the following sections.
NOTE
The system description, VLAN name, and power-via-MDI information TLVs are not automatically
enabled. The following sections show how to enable these advertisements.
General system information
Except for the system description, the Dell PowerConnect device will advertise the following system
information when LLDP is enabled on a global basis:
Management Address
A management address is normally an IPv4 or IPv6 address that can be used to manage the
device. Management address advertising has two modes: default, or explicitly configured. The
default mode is used when no addresses are configured to be advertised for a given port. If any
addresses are configured to be advertised for a given port, then only those addresses are
advertised. This applies across address types, so for example, if just one IPv4 address is explicitly
configured to be advertised for a port, then no IPv6 addresses will be advertised for that port (since
none were configured to be advertised), even if IPv6 addresses are configured within the system.
If no management address is explicitly configured to be advertised, the device will use the first
available IPv4 address and the first available IPv6 address (so it may advertise IPv4, IPv6 or both).
A Layer 3 switch will select the first available address of each type from those configured on the
following types of interfaces, in the following order of preference:
700
System name
VLAN name (not automatically advertised)
Untagged VLAN ID
Link aggregation information
MAC/PHY configuration and status
Maximum frame size
Power-via-MDI information (not automatically advertised)
Management address
Port description
System capabilities
System description (not automatically advertised)
System name
Physical port on which LLDP will be transmitting the packet
Virtual router interface (VE) on a VLAN that the port is a member of
Dedicated management port
Loopback interface
Virtual router interface (VE) on any other VLAN
Other physical port
PowerConnect B-Series FCX Configuration Guide
53-1002266-01

Advertisement

Table of Contents
loading

Table of Contents