Dell PowerConnect B-FCXs Configuration Manual page 1095

Powerconnect b-series fcx
Hide thumbs Also See for PowerConnect B-FCXs:
Table of Contents

Advertisement

To perform a soft reset of a neighbor session and send ORFs to the neighbor, enter a command
such as the following.
PowerConnect#clear ip bgp neighbor 1.2.3.4 soft in prefix-list
Syntax: clear ip bgp neighbor <ip-addr> [soft in prefix-filter]
If you use the soft in prefix-filter parameter, the Layer 3 Switch sends the updated IP prefix list to
the neighbor as part of its route refresh message to the neighbor.
NOTE
If the Layer 3 Switch or the neighbor is not configured for cooperative filtering, the command sends
a normal route refresh message.
Displaying cooperative filtering information
You can display the following cooperative filtering information:
To display the cooperative filtering configuration on the Layer 3 Switch, enter a command such as
the following. The line shown in bold type shows the cooperative filtering status.
PowerConnect#show ip bgp neighbors 10.10.10.1
1
Syntax: show ip bgp neighbors <ip-addr>
To display the ORFs received from a neighbor, enter a command such as the following.
PowerConnect#show ip bgp neighbors 10.10.10.1 received prefix-filter
ip prefix-list 10.10.10.1: 4 entries
Syntax: show ip bgp neighbors <ip-addr> received prefix-filter
PowerConnect B-Series FCX Configuration Guide
53-1002266-01
The cooperative filtering configuration on the Layer 3 Switch.
The ORFs received from neighbors.
IP Address: 10.10.10.1, AS: 65200 (IBGP), RouterID: 10.10.10.1
State: ESTABLISHED, Time: 0h0m7s, KeepAliveTime: 60, HoldTime: 180
RefreshCapability: Received
CooperativeFilteringCapability: Received
Messages:
Open
Sent
: 1
Received: 1
Last Update Time: NLRI
Tx: ---
Last Connection Reset Reason:Unknown
Notification Sent:
Notification Received: Unspecified
TCP Connection state: ESTABLISHED
Byte Sent:
110, Received: 110
Local host:
10.10.10.2, Local
Remote host: 10.10.10.1, Remote Port: 179
ISentSeq:
460
TotSent:
111
IRcvSeq:
7349
TotalRcv:
111
SendQue:
seq 5 permit 10.10.0.0/16 ge 18 le 28
seq 10 permit 20.20.10.0/24
seq 15 permit 30.0.0.0/8 le 32
seq 20 permit 40.10.0.0/16 ge 18
Update
KeepAlive Notification Refresh-Req
0
1
0
0
1
0
Withdraw
---
Unspecified
Port: 8138
SendNext:
ReTrans:
RcvNext:
7460
DupliRcv:
0
RcvQue:
Filtering
1
1
NLRI
Withdraw
Rx: ---
---
571
TotUnAck:
0
UnAckSeq:
SendWnd:
16384
0
RcvWnd:
16384
0
CngstWnd:
30
0
571
5325
1053

Advertisement

Table of Contents
loading

Table of Contents