Dell PowerConnect B-FCXs Configuration Manual page 1290

34
Displaying 802.1X information
TABLE 212
This field...
PAE Capability
system-auth-control
re-authentication
global-filter-strict-security
quiet-period
tx-period
supp-timeout
server-timeout
maxreq
re-authperiod
Protocol Version
To display information about the 802.1X configuration on an individual port, enter a command such
as the following.
1248
Output from the show dot1x command
Displays...
The Port Access Entity (PAE) role for the Dell PowerConnect device. This is always
"Authenticator Only".
Whether system authentication control is enabled on the device. The
dot1x-enable command enables system authentication control on the device.
Whether periodic re-authentication is enabled on the device. Refer to
"Configuring periodic re-authentication"
When periodic re-authentication is enabled, the device automatically
re-authenticates Clients every 3,600 seconds by default.
Whether strict security mode is enabled or disabled globally. Refer to
and enabling strict security mode for dynamic filter assignment"
When the Dell PowerConnect device is unable to authenticate a Client, the
amount of time the Dell PowerConnect device waits before trying again (default
60 seconds).
Refer to "Setting the quiet period"
change this setting.
When a Client does not send back an EAP-response/identity frame, the amount
of time the Dell PowerConnect device waits before retransmitting the
EAP-request/identity frame to a Client (default 30 seconds).
Refer to "Setting the wait interval for EAP frame retransmissions"
for information on how to change this setting.
When a Client does not respond to an EAP-request frame, the amount of time
before the Dell PowerConnect device retransmits the frame.
Refer to "Setting the wait interval for EAP frame retransmissions"
for information on how to change this setting.
When the Authentication Server does not respond to a message sent from the
Client, the amount of time before the Dell PowerConnect device retransmits the
message.
Refer to "Specifying a timeout for retransmission of messages to the
authentication server"
setting.
The number of times the Dell PowerConnect device retransmits an
EAP-request/identity frame if it does not receive an EAP-response/identity frame
from a Client (default 2 times).
Refer to "Setting the maximum number of EAP frame retransmissions"
page 1241 for information on how to change this setting.
How often the device automatically re-authenticates Clients when periodic
re-authentication is enabled (default 3,600 seconds).
Refer to "Configuring periodic re-authentication"
how to change this setting.
The version of the 802.1X protocol in use on the device.
on page 1239.
on page 1240 for information on how to
on page 1242 for information on how to change this
on page 1239 for information on
PowerConnect B-Series FCX Configuration Guide
"Disabling
on page 1235.
on page 1240
on page 1241
on
53-1002266-01