Displaying Mac-Based Vlan Logging; Clearing Mac-Vlan Information; Sample Application - Dell PowerConnect B-FCXs Configuration Manual

Displaying MAC-based VLAN logging

Enter the following command to display MAC-based VLAN logging activity.
PowerConnect#show logging
Syslog logging: enabled (0 messages dropped, 0 flushes, 15 overruns)
Static Log Buffer
0d00h00m12s:A:System:
Dynamic Log Buffer (50 lines):
0d18h46m28s:I:running-config was changed from console
0d02h12m25s:A:MAC Based Vlan Mapping failed for [0000.1111.0108 ] on port 0/2/1
(Invalid User)
0d02h08m52s:A:MAC Based Vlan Mapping failed for [0000.1111.011b ] on port 0/2/1
(Invalid User)
0d02h05m01s:A:MAC Based Vlan Mapping failed for [0000.1111.00df ] on port 0/2/1
(Invalid User)
0d02h01m15s:A:MAC Based Vlan Mapping failed for [0000.1111.0108 ] on port 0/2/1
(Invalid User)
0d02h01m15s:A:MAC Based Vlan Mapping failed for [0000.1111.0107 ] on port 0/2/1
(Invalid User)
0d01h58m43s:N:MAC Based Vlan Enabled on port 0/2/1
0d01h58m32s:N:MAC Based Vlan Disabled on port 0/2/1
0d01h39m00s:I:running-config was changed from console
0d01h38m28s:I:System: Interface ethernet 0/1/47, state up
0d01h38m27s:I:System: Interface ethernet 0/1/46, state up
0d01h38m27s:I:System: Interface ethernet 0/1/34, state up
0d01h38m27s:I:System: Interface ethernet 0/1/25, state up

Clearing MAC-VLAN information

Enter the following command to clear MAC-VLAN information. Add the interface id to clear
information for a specific interface.
PowerConnect#clear table-mac-vlan <interface>

Sample application

Figure 111
Dell PowerConnect device. In this configuration, three host PCs are connected to port e 0/1/1
through a hub.
Host A MAC address is statically configured on port e 0/1/1. The profile for Host B MAC address on
the RADIUS server specifies that the PC should be assigned to VLAN 2. Host C profile does not exist
in the RADIUS server, and will be put into a restricted VLAN.
PowerConnect B-Series FCX Configuration Guide
53-1002266-01
Buffer logging: level ACDMEINW, 50 messages logged
level code: A=alert C=critical D=debugging M=emergency E=error
Power supply 1
illustrates a sample configuration that uses MAC-based VLAN on port e 0/1/1 on the
Clearing MAC-VLAN information
is up
15
543