Dell PowerConnect B-FCXs Configuration Manual page 495

FIGURE 96
To configure the VLANs shown in
1. To permanently assign ports 1 – 8 and port 25 to IP subnet VLAN 1.1.1.0, enter the following
2. To permanently assign ports 9 – 16 and port 25 to IP subnet VLAN 1.1.2.0, enter the following
3. To permanently assign ports 17 – 25 to IP subnet VLAN 1.1.3.0, enter the following commands.
4. To permanently assign ports 1 – 12 and port 25 to IPX network 1 VLAN, enter the following
5. To permanently assign ports 12 – 25 to Appletalk VLAN, enter the following commands.
PowerConnect B-Series FCX Configuration Guide
53-1002266-01
Configuring IP subnet, IPX network and protocol-based VLANs
Protocol-based (Layer 3) VLANs
Port25
IP-Subnet 1
IP-Subnet 2
IP-Subnet 3
IPX Net 1
Appletalk Cable 100
commands.
PowerConnect(config-vlan-2)# ip-subnet 1.1.1.0/24 name Green
PowerConnect(config-vlan-ip-subnet)# no dynamic
PowerConnect(config-vlan-ip-subnet)# static ethernet 1 to 8 ethernet 25
commands.
PowerConnect(config-vlan-3)# ip-subnet 1.1.2.0/24 name Yellow
PowerConnect(config-vlan-ip-subnet)# no dynamic
PowerConnect(config-vlan-ip-subnet)# static ethernet 9 to 16 ethernet 25
PowerConnect(config-vlan-4)# ip-subnet 1.1.3.0/24 name Brown
PowerConnect(config-vlan-ip-subnet)# no dynamic
PowerConnect(config-vlan-ip-subnet)# static ethernet 17 to 25
commands.
PowerConnect(config-ip-subnet)# ipx-network 1 ethernet_802.3 name Blue
PowerConnect(config-ipx-network)# no dynamic
PowerConnect(config-ipx-network)# static ethernet 1 to 12 ethernet 25
PowerConnect(config-ipx-network)#
Device
Port25
Layer 3 Switch
IP-Subnet 1
Ports 1-16, 25
IPX Net 1
Figure 96, use the following procedure.
IP-Subnet 2
IP-Subnet 3
Ports 17-25
Appletalk Cable 100
13
453