Displaying Candidate Rp Information - Dell PowerConnect B-FCXs Configuration Manual

NOTE
When the product of the number of active PIM interfaces multiplied by the number of multicast
streams exceeds the total number of MLL, the CLI displays the message, "MLL pool out of memory".
NOTE
The total number of MLL available changes according to the hardware configuration.

Displaying candidate RP information

To display candidate RP information, enter the following command at any CLI level.
PowerConnect#show ip pim rp-candidate
Next Candidate-RP-advertisement in 00:00:10
RP: 207.95.7.1
Candidate-RP-advertisement period: 60
This example show information displayed on a Layer 3 Switch that is a candidate RP. The following
example shows the message displayed on a Layer 3 Switch that is not a candidate RP.
PowerConnect#show ip pim rp-candidate
This system is not a Candidate-RP.
Syntax: show ip pim rp-candidate
This display shows the following information.
TABLE 131
This field...
Candidate-RP-advertisement
in
RP
group prefixes
Candidate-RP-advertisement
period
Displaying RP-to-group mappings
To display RP-to-group-mappings, enter the following command at any CLI level.
PowerConnect#show ip pim rp-map
Number of group-to-RP mappings: 6
Group address
-------------------------------
PowerConnect B-Series FCX Configuration Guide
53-1002266-01
group prefixes:
224.0.0.0 / 4
Output of show ip pim rp-candidate
Displays...
Indicates how many seconds will pass before the BSR sends its next RP
message.
NOTE: This field appears only if this Layer 3 Switch is a candidate RP.
Indicates the IP address of the Rendezvous Point (RP).
NOTE: This field appears only if this Layer 3 Switch is a candidate RP.
Indicates the multicast groups for which the RP listed by the previous field is a
candidate RP.
NOTE: This field appears only if this Layer 3 Switch is a candidate RP.
Indicates how frequently the BSR sends candidate RP advertisement messages.
NOTE: This field appears only if this Layer 3 Switch is a candidate RP.
RP address
25
PIM Sparse
755