Cli Commands - Dell PowerConnect B-FCXs Configuration Manual

FIGURE 125
Server 10.10.10.100
Client 10.10.10.1
for 230.1.1.1

CLI commands

The following are the CLI commands for the configuration example shown in
Figure
1. On the device, configure IGMP Snooping on VLAN 10.
2. On the device, enable PIM routing between VLAN/VE 20 and Interface e 13.
PowerConnect B-Series FCX Configuration Guide
53-1002266-01
IP multicast protocols and IGMP snooping on the same device
Example 2: IGMP Snooping and PIM Forwarding
e1
Vlan 10
e4
125.
PowerConnect(config)#vlan 10 by port
PowerConnect(config-vlan-10)#untagged e 1 to 4
Added untagged port(s) ethe 1 to 4 to port-vlan 10.
PowerConnect(config-vlan-10)#router-interface ve 10
PowerConnect(config-vlan-10)#ip multicast active
PowerConnect(config-vlan-10)#interface ve 10
PowerConnect(config-vif-10)#ip address 10.10.10.10/24
PowerConnect(config)#vlan 20 by port
PowerConnect(config-vlan-20)#untagged e 21 to 24
Added untagged port(s) ethe 21 to 24 to port-vlan 20.
PowerConnect(config-vlan-20)#router-interface ve 20
PowerConnect(config-vlan-20)#exit
PowerConnect(config)#router pim
PowerConnect(config-pim-router)#exit
PowerConnect(config)#interface ve 20
PowerConnect(config-vif-20)#ip address 20.20.20.10/24
PowerConnect(config-vif-20)#ip pim
Both Sources for
Group 230.1.1.1
Vlan 20
(with VE 20)
Device
e21
(DUT)
e13
20.20.20.x/24
30.30.30.x/24
e3
40.40.40.x/24
e4
Router
25
Server 20.20.20.1
Client 40.40.40.1
for 230.1.1.1
Figure 124 and
781