Dell PowerConnect B-FCXs Configuration Manual page 1125

Displaying information for a specific route
To display BGP4 network information by specifying an IP address within the network, enter a
command such as the following at any level of the CLI.
PowerConnect#show ip bgp 9.3.4.0
Number of BGP Routes matching display condition : 1
Status codes: s suppressed, d damped, h history, * valid, > best, i internal
Origin codes: i - IGP, e - EGP, ? - incomplete
*>
Syntax: show ip bgp [route] <ip-addr>/<prefix> [longer-prefixes] | <ip-addr>
If you use the route option, the display for the information is different, as shown in the following
example.
PowerConnect#show ip bgp route 9.3.4.0
Number of BGP Routes matching display condition : 1
Status A:AGGREGATE B:BEST b:NOT-INSTALLED-BEST C:CONFED_EBGP D:DAMPED
1
These displays show the following information.
TABLE 189
Field
Number of BGP Routes
matching display condition
Status codes
Prefix
Next Hop
Metric
LocPrf
PowerConnect B-Series FCX Configuration Guide
53-1002266-01
Network Next Hop
9.3.4.0/24 192.168.4.106
Last update to IP routing table: 0h11m38s, 1 path(s) installed:
Gateway
192.168.2.1
Route is advertised to 1 peers:
20.20.20.2(65300)
E:EBGP H:HISTORY I:IBGP L:LOCAL M:MULTIPATH S:SUPPRESSED F:FILTERED
Prefix
9.3.4.0/24
AS_PATH: 65001 4355 1 1221
Last update to IP routing table: 0h12m1s, 1 path(s) installed:
Gateway
192.168.2.1
Route is advertised to 1 peers:
20.20.20.2(65300)
BGP4 network information
Metric LocPrf Weight Path
Port
2/1
Next Hop Metric
192.168.4.106
Port
2/1
Description
The number of routes that matched the display parameters you entered. This is
the number of routes displayed by the command.
A list of the characters the display uses to indicate the route status. The status
code appears in the left column of the display, to the left of each route. The
status codes are described in the command output.
NOTE: This field appears only if you do not enter the route option.
The network address and prefix.
The next-hop router for reaching the network from the Layer 3 Switch.
The value of the route MED attribute. If the route does not have a metric, this
field is blank.
The degree of preference for this route relative to other routes in the local AS.
When the BGP4 algorithm compares routes on the basis of local preferences,
the route with the higher local preference is chosen. The preference can have a
value from 0 through 4294967295.
Displaying BGP4 information
100 0 65001 4355 1 1221 ?
LocPrf Weight Status
100 0
30
BE
1083