•
•
Displaying general OSPF configuration information
To display general OSPF configuration information, enter the following command at any CLI level.
PowerConnect#show ip ospf config
Router OSPF: Enabled
Redistribution: Disabled
Default OSPF Metric: 10
OSPF Redistribution Metric: Type2
OSPF External LSA Limit: 25000
OSPF Database Overflow Interval: 0
RFC 1583 Compatibility: Enabled
Router id: 192.85.2.1
Interface State Change Trap:
Virtual Interface State Change Trap:
Neighbor State Change Trap:
Virtual Neighbor State Change Trap:
Interface Configuration Error Trap:
Virtual Interface Configuration Error Trap:
Interface Authentication Failure Trap:
Virtual Interface Authentication Failure Trap:
Interface Receive Bad Packet Trap:
Virtual Interface Receive Bad Packet Trap:
Interface Retransmit Packet Trap:
Virtual Interface Retransmit Packet Trap:
Originate LSA Trap:
Originate MaxAge LSA Trap:
Link State Database Overflow Trap:
Link State Database Approaching Overflow Trap:
OSPF Area currently defined:
Area-ID
0
OSPF Interfaces currently defined:
Ethernet Interface: 3/1-3/2
ip ospf md5-authentication-key-activation-wait-time 300
ip ospf area 0
Ethernet Interface: v1
ip ospf md5-authentication-key-activation-wait-time 300
ip ospf area 0
Ethernet Interface: 2/1
ip ospf auth-change-wait-time 300
ip ospf cost 40
ip ospf area 0
Syntax: show ip ospf config
PowerConnect B-Series FCX Configuration Guide
53-1002266-01
Trap state information – refer to
OSPF graceful restart - refer to
Area-Type Cost
normal
Displaying OSPF information
"Displaying OSPF trap status"
"Displaying OSPF graceful restart information"
0
on page 978.
on page 978.
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
29
967