Enabling 802.1X Accounting; Displaying 802.1X Information; Displaying 802.1X Configuration Information - Dell PowerConnect B-FCXs Configuration Manual

Enabling 802.1X accounting

To enable 802.1X accounting, enter the following command.
PowerConnect(config)#aaa accounting dot1x default start-stop radius none
Syntax: aaa accounting dot1x default start-stop radius | none
radius – Use the list of all RADIUS servers that support 802.1X for authentication.
none – Use no authentication. The client is automatically authenticated without the device using
information supplied by the client.
NOTE
If you specify both radius and none, make sure radius comes before none.

Displaying 802.1X information

You can display the following 802.1X-related information:
•
•
•
•
•

Displaying 802.1X configuration information

To display information about the 802.1X configuration on the Dell PowerConnect device, enter the
following command.
PowerConnect#show dot1x
PAE Capability:
system-auth-control: Enable
re-authentication: Disable
global-filter-strict-security: Enable
quiet-period:
tx-period:
supptimeout:
servertimeout:
maxreq:
re-authperiod:
Protocol Version:
Syntax: show dot1x
The following table describes the information displayed by the show dot1x command.
PowerConnect B-Series FCX Configuration Guide
53-1002266-01
The 802.1X configuration on the device and on individual ports
Statistics about the EAPOL frames passing through the device
802.1X-enabled ports dynamically assigned to a VLAN
User-defined and dynamically applied MAC address filters and IP ACLs currently active on the
device
The 802.1X multiple-host configuration
Authenticator Only
60 Seconds
30 Seconds
30 Seconds
30 Seconds
2
3600 Seconds
1
Displaying 802.1X information
34
1247