Dell PowerConnect B-FCXs Configuration Manual page 1171

Syntax: show ip vrrp-extended brief | ethernet [<slotnum>/]<portnum> | ve <num> | stat
The brief parameter displays summary information. Refer to
page 1122.
If you specify a port, the <slotnum> parameter is required on chassis devices.
The <portnum> parameter specifies an Ethernet port. If you use this parameter, the command
displays detailed VRRP or VRRPE information only for the specified port. Refer to
detailed information"
The ve <num> parameter specifies a virtual interface. If you use this parameter, the command
displays detailed VRRP or VRRPE information only for the specified virtual interface. Refer to
"Displaying detailed information"
The statistic parameter displays statistics. This parameter is required for displaying the statistics.
This display shows the following information.
TABLE 198
This field...
Interface statistics
Interface
rxed vrrp header error count
rxed vrrp auth error count
rxed vrrp auth passwd mismatch
error count
rxed vrrp vrid not found error
count
VRID statistics
rxed arp packet drop count
rxed ip packet drop count
rxed vrrp port mismatch count
rxed vrrp ip address mismatch
count
rxed vrrp hello interval mismatch
count
rxed vrrp priority zero from
master count
rxed vrrp higher priority count
PowerConnect B-Series FCX Configuration Guide
53-1002266-01
on page 1123.
on page 1123.
CLI display of VRRP or VRRPE statistics
Displays...
The interface on which VRRP or VRRPE is configured. If VRRP or VRRPE is
configured on more than one interface, the display lists the statistics
separately for each interface.
The number of VRRP or VRRPE packets received by the interface that had a
header error.
The number of VRRP or VRRPE packets received by the interface that had an
authentication error.
The number of VRRP or VRRPE packets received by the interface that had a
password value that does not match the password used by the interface for
authentication.
The number of VRRP or VRRPE packets received by the interface that
contained a VRID that is not configured on this interface.
The number of ARP packets addressed to the VRID that were dropped.
The number of IP packets addressed to the VRID that were dropped.
The number of packets received that did not match the configuration for the
receiving interface.
The number of packets received that did not match the configured IP
addresses.
The number of packets received that did not match the configured Hello
interval.
The current Master has resigned.
The number of VRRP or VRRPE packets received by the interface that had a
higher backup priority for the VRID than this Layer 3 Switch backup priority for
the VRID.
Displaying VRRP and VRRPE information
"Displaying summary information"
31
on
"Displaying
1129