Dell PowerConnect B-FCXs Configuration Manual page 497

Configuring IP subnet, IPX network, and protocol-based VLANs within port-based VLANs
FIGURE 97
Port1
VLAN 2 VLAN 3 VLAN 4
To configure the Layer 3 VLANs on the Layer 2 Switches in
Configuring device-A
Enter the following commands to configure device-A.
1. Create port-based VLAN 2 and assign the untagged and tagged ports that will participate in
2. Enable STP and set the priority to force device-A to be the root bridge for VLAN 2.
3. Create the IP and IPX protocol-based VLANs and statically assign the ports within VLAN 2 that
PowerConnect B-Series FCX Configuration Guide
53-1002266-01
More protocol-based VLANs
Device
Device
Port9 Port17
V2
Device-A
Device-A
VLAN 2
this VLAN.
PowerConnect-A >en
PowerConnect-A# config t
PowerConnect-A(config)# vlan 2 name IP_IPX_Protocol
PowerConnect-A(config-vlan-2)# untagged e1 to 8
PowerConnect-A(config-vlan-2)# tagged e25 to 26
PowerConnect-A(config-vlan-2)# spanning-tree
PowerConnect-A(config-vlan-2)# spanning-tree priority 500
PowerConnect-A(config-vlan-2)#
will be associated with each protocol-based VLAN.
PowerConnect-A(config-vlan-2)# ip-proto name Red
PowerConnect-A(config-vlan-ip-proto)# no dynamic
PowerConnect-A(config-vlan-ip-proto)# static e1 to 4 e25 to 26
PowerConnect-A(config-vlan-ip-proto)# exclude e5 to 8
PowerConnect-A(config-vlan-ip-proto)# ipx-proto name Blue
PowerConnect-A(config-vlan-ipx-proto)# no dynamic
PowerConnect-A(config-vlan-ipx-proto)# static e1 e5 to 8 e25 to 26
PowerConnect-A(config-vlan-ipx-proto)# exclude e2 to 4
V3
V4
VLAN 2
Device-C
Device-C
VLAN 3 VLAN 4
Figure
Device-B
Device-B
VLAN 4
VLAN 3
= STP Blocked VLAN
97, use the following procedure.
13
455