Dell PowerConnect B-FCXs Configuration Manual page 945

Powerconnect b-series fcx

Hide thumbs Also See for PowerConnect B-FCXs:

Table of Contents

This field...

Available vidx

Displaying status of MLD snooping traffic

To display status information for MLD snooping traffic, enter the following command.

PowerConnect#show ipv6 mld-snooping traffic

MLD snooping: Total Recv: 32208, Xmit: 166

Q: query, Qry: general Q,

Syntax: show ipv6 mld-snooping traffic

The following table describes the information displayed by the show ipv6 mld-snooping traffic

PowerConnect B-Series FCX Configuration Guide

53-1002266-01

Displays the number of resource failures.

NOTE: It is important to pay close attention to this field.

The upper limit of this expandable field. The MLD group limit is configured using the system-max

mld-max-group-addr command. The snoop mcache entry limit is configured using the

system-max mld-snoop-mcache command.

The number of memory allocation. This number should continue to increase.

The size of a unit (in bytes).

The initial allocated amount of memory.

NOTE: This number can be increased. More memory can be allocated if necessary.

The output interface (OIF) port mask used by mcache. The entire device has a maximum of

4096 vidx. Different mcaches with the same OIF share the same vidx. If vidx is not available, the

stream cannot be hardware-switched.

G-Qry: group Q,

General Query

Number of general MLDv1 queries received or sent.

Number of general MLDv2 snooping queries received or sent.

Number of group specific queries received or sent.

Number of group source specific queries received or sent.

The membership report.

The MLDv1 membership report.

The MLDv2 membership report.

Number of source addresses that were included in the traffic.

Configuring MLD snooping

GSQry: group-source Q, Mbr: member

Troubleshooting