Modifying A Port-Based Vlan - Dell PowerConnect B-FCXs Configuration Manual

13
Routing between VLANs

Modifying a port-based VLAN

You can make the following modifications to a port-based VLAN:
•
•
Removing a port-based VLAN
Suppose you want to remove VLAN 5 from the example in
procedure.
1. Access the global CONFIG level of the CLI on device-A by entering the following commands.
2. Enter the following command.
3. Enter the following commands to exit the CONFIG level and save the configuration to the
4. Repeat steps 1 – 3 on device-B.
Syntax: no vlan <vlan-id> by port
Removing a port from a VLAN
Suppose you want to remove port 11 from VLAN 4 on device-A shown in
the following procedure.
1. Access the global CONFIG level of the CLI on device-A by entering the following command.
2. Access the level of the CLI for configuring port-based VLAN 4 by entering the following
3. Enter the following commands.
450
Add or delete a VLAN port.
Enable or disable STP.
PowerConnect-A> enable
No password has been assigned yet...
PowerConnect-A# configure terminal
PowerConnect-A(config)#
PowerConnect-A(config)# no vlan 5
PowerConnect-A(config)#
system-config file on flash memory.
PowerConnect-A(config)#
PowerConnect-A(config)# end
PowerConnect-A# write memory
PowerConnect-A#
PowerConnect-A> enable
No password has been assigned yet...
PowerConnect-A# configure terminal
PowerConnect-A(config)#
command.
PowerConnect-A(config)#
PowerConnect-A(config)# vlan 4
PowerConnect-A(config-vlan-4)#
PowerConnect-A(config-vlan-4)#
PowerConnect-A(config-vlan-4)# no untagged ethernet 11
deleted port ethe 11 from port-vlan 4.
PowerConnect-A(config-vlan-4)#
Figure 95. To do so, use the following
Figure 95. To do so, use
PowerConnect B-Series FCX Configuration Guide
53-1002266-01