Configuration Example For Standard Numbered Acls; Configuring Standard Named Acls - Dell PowerConnect B-FCXs Configuration Manual

The log argument configures the device to generate Syslog entries and SNMP traps for packets that
are denied by the access policy.
NOTE
You can enable logging on ACLs and filters that support logging even when the ACLs and filters are
already in use. To do so, re-enter the ACL or filter command and add the log parameter to the end
of the ACL or filter. The software replaces the ACL or filter command with the new one. The new ACL
or filter, with logging enabled, takes effect immediately.
The in parameter applies the ACL to incoming traffic on the interface to which you apply the ACL.
You can apply the ACL to an Ethernet port or virtual interface.
NOTE
If the ACL is for a virtual routing interface, you also can specify a subset of ports within the VLAN
containing that interface when assigning an ACL to the interface.

Configuration example for standard numbered ACLs

To configure a standard ACL and apply it to incoming traffic on port 1/1, enter the following
commands.
PowerConnect(config)#access-list 1 deny host 209.157.22.26 log
PowerConnect(config)#access-list 1 deny 209.157.29.12 log
PowerConnect(config)#access-list 1 deny host IPHost1 log
PowerConnect(config)#access-list 1 permit any
PowerConnect(config)#int eth 1/1
PowerConnect(config-if-1/1)#ip access-group 1 in
PowerConnect(config)#write memory
The commands in this example configure an ACL to deny packets from three source IP addresses
from being received on port 1/1. The last ACL entry in this ACL permits all packets that are not
explicitly denied by the first three ACL entries.

Configuring standard named ACLs

This section describes how to configure standard named ACLs with alphanumeric IDs. This section
also provides configuration examples.
Standard ACLs permit or deny packets based on source IP address. You can configure up to 99
standard named ACLs. There is no limit to the number of ACL entries an ACL can contain except
for the system-wide limitation. For the number of ACL entries supported on a device, refer to
IDs and entries"
The commands for configuring named ACL entries are different from the commands for configuring
numbered ACL entries. The command to configure a numbered ACL is access-list. The command
for configuring a named ACL is ip access-list. In addition, when you configure a numbered ACL
entry, you specify all the command parameters on the same command. When you configure a
named ACL, you specify the ACL type (standard or extended) and the ACL name with one command,
which places you in the configuration level for that ACL. Once you enter the configuration level for
the ACL, the command syntax is the same as the syntax for numbered ACLs.
PowerConnect B-Series FCX Configuration Guide
53-1002266-01
on page 548.
Configuring standard named ACLs
16
"ACL
553