Dell PowerConnect B-FCXs Configuration Manual page 1012

29
Displaying OSPF information
PowerConnect#show ip ospf neighbor detail
Port
9/1
10/1
1/1-1/8
2/1-2/2
Syntax: show ip ospf neighbor [router-id <ip-addr>] | [<num>] | [detail]
The router-id <ip-addr> parameter displays only the neighbor entries for the specified router.
The <num> parameter displays only the entry in the specified index position in the neighbor table.
For example, if you enter "1", only the first entry in the table is displayed.
The detail parameter displays detailed information about the neighbor routers.
These displays show the following information.
TABLE 176
Field
Port
Address
Pri
970
Address
20.2.0.2
Second-to-dead:39
20.3.0.2
Second-to-dead:36
23.5.0.1
Second-to-dead:33
23.2.0.1
Second-to-dead:33
CLI display of OSPF neighbor information
Description
The port through which the Layer 3 Switch is connected to the neighbor.
The port on which an OSPF point-to-point link is configured.
The IP address of this Layer 3 Switch interface with the neighbor.
The OSPF priority of the neighbor:
•
For multi-access networks, the priority is used during election of the Designated Router
(DR) and Backup designated Router (BDR).
•
For point-to-point links, this field shows one of the following values:
•
1 = point-to-point link
•
3 = point-to-point link with assigned subnet
Pri State Neigh Address
1 FULL/DR 20.2.0.1
1 FULL/BDR 20.3.0.1
1 FULL/DR 23.5.0.2
1 FULL/DR 23.2.0.2
PowerConnect B-Series FCX Configuration Guide
Neigh ID Ev Op Cnt
2.2.2.2 6 2 0
3.3.3.3 5 2 0
16.16.16.16 6 2 0
15.15.15.15 6 2 0
53-1002266-01