Troubleshooting Secure-Setup - Dell PowerConnect B-FCXs Configuration Manual

3. To resolve the mismatch, you must remove the configuration for stack unit 3. Use the following
4. When you have successfully deleted the mismatched stack unit, a re-election is triggered, and
Follow the steps given below to recover from an image mismatch.
1. Use the copy flash flash command to replace a mis-matched image with the correct image.
2. Reset the unit. After the reset, the unit will contain the new image and the mis-match condition

Troubleshooting secure-setup

Secure-setup can be used to form linear and ring stack topologies. For information about the
procedure, refer to
secure-setup"
should be detected, perform the following checks:
•
•
•
•
•
•
PowerConnect B-Series FCX Configuration Guide
53-1002266-01
PowerConnectt# show running config
stack unit 1
module 1 FCX-24-port-management-module
module 3 FCX-cx4-2-port-16g-module
module 4 FCX-xfp-2-port-16g-module
priority 128
stack unit 2
module 1 FCX-24-port-management-module
module 3 FCX-xfp-2-port-16g-module
stack unit 3
module 1 FCX-48-port-management-module
module 2 FCX-cx4-2-port-16g-module
module 3 FCX-cx4-2-port-16g-module
stack enable
command.
PowerConnect# no stack unit 3
If you are unable to remove the configuration because of a multi-slot trunk configuration, it
means secure-setup cannot overwrite the Active Controller configuration due to multi-slot
trunking configurations on the ports of the unit to be overwritten. You must first manually
remove the multi-slot trunk configuration.
the Active Controller learns the correct module configuration from the Standby Controller or
from other stack members.
Refer to "Copying the flash image to a stack unit from the Active Controller"
will not exist. To verify, use the show stack command.
"Scenario 1 - Configuring a three-member IronStack in a ring topology using
on page 101. During this procedure, if secure-setup does not detect all the units that
Make sure that all the cables are properly connected
Make sure that all the relevant ports are in UP state
Make sure that all the units are running the same image
Make sure that you issue the stack enable command only on the unit that will serve as the
Active Controller
Make sure that stack disable is not configured on any prospective members
Make sure that the connection is sequential (refer to
Sequential Connection)
Image mismatches
on page 126.
"IronStack terminology" on page 96,
5
157