Dell PowerConnect B-FCXs Configuration Manual page 747

Syntax: [no] lldp advertise port-vlan-id ports ethernet <port-list> | all
For <port-list>, specify the ports in one of the following formats:
•
You can list all of the ports individually, use the keyword to to specify ranges of ports, or a
combination of both. To apply the configuration to all ports on the device, use the keyword all
instead of listing the ports individually. Note that using the keyword all may cause undesirable
effects on some ports. For example, if you configure all ports to advertise their VLAN name, and
the configuration includes ports that are not members of any VLAN, the system will warn of the
misconfigurations on non-member VLAN ports. The configuration will be applied to all ports,
however, the ports that are not members of any VLAN will not send VLAN name advertisements.
802.3 capabilities
Except for Power-via-MDI information, the Dell PowerConnect device will advertise the following
802.3 attributes when LLDP is enabled on a global basis:
•
•
•
•
Link aggregation
The link-aggregation TLV indicates the following:
•
•
•
Dell PowerConnect devices advertise link aggregation information about standard link aggregation
(LACP) as well as static trunk configuration.
By default, link-aggregation information is automatically advertised when LLDP is enabled on a
global basis. To disable this advertisement, enter a command such as the following.
PowerConnect(config)#no lldp advertise link-aggregation ports e 2/12
Syntax: [no] lldp advertise link-aggregation ports ethernet <port-list> | all
The link aggregation advertisement will appear similar to the following on the remote device, and in
the CLI display output on the Dell PowerConnect device (show lldp local-info).
For <port-list>, specify the ports in one of the following formats:
•
You can list all of the ports individually, use the keyword to to specify ranges of ports, or a
combination of both. To apply the configuration to all ports on the device, use the keyword all
instead of listing the ports individually. Note that using the keyword all may cause undesirable
effects on some ports. For example, if you configure all ports to advertise their VLAN name, and
the configuration includes ports that are not members of any VLAN, the system will warn of the
misconfigurations on non-member VLAN ports. The configuration will be applied to all ports,
however, the ports that are not members of any VLAN will not send VLAN name advertisements.
PowerConnect B-Series FCX Configuration Guide
53-1002266-01
PowerConnect B-Series FCX stackable switches – <stack-unit/slotnum/portnum>
Link aggregation information
MAC/PHY configuration and status
Maximum frame size
Power-via-MDI information (not automatically advertised)
Whether the link is capable of being aggregated
Whether the link is currently aggregated
The primary trunk port
Link aggregation: not capable
PowerConnect B-Series FCX stackable switches – <stack-unit/slotnum/portnum>
24
Configuring LLDP
705