Dell PowerConnect B-FCXs Configuration Manual page 926

26
Displaying IP configuration information and statistics
•
•
•
Displaying global IP configuration information
To display the Layer 2 Switch IP address and default gateway, enter the following command.
PowerConnect# show ip
Default router address: 192.168.1.1
TFTP server address: None
Configuration filename: None
Syntax: show ip
This display shows the following information.
TABLE 166
This field...
IP configuration
Switch IP address
Subnet mask
Default router address
Most recent TFTP access
TFTP server address
Configuration filename
Image filename
Displaying ARP entries
To display the entries the Layer 2 Switch has placed in its ARP cache, enter the following command
from any level of the CLI.
PowerConnect# show arp
Total Arp Entries : 1, maximum capacity: 1000
No.
1
884
Global IP settings – refer to
ARP entries – refer to "Displaying ARP entries"
IP traffic statistics – refer to
Switch IP address: 192.168.1.2
Subnet mask: 255.255.255.0
Image filename: None
CLI display of global IP configuration information – Layer 2 Switch
Displays...
The management IP address configured on the Layer 2 Switch. Specify this
address for Telnet or Web management access.
The subnet mask for the management IP address.
The address of the default gateway, if you specified one.
The IP address of the most-recently contacted TFTP server, if the switch has
contacted a TFTP server since the last time the software was reloaded or the
switch was rebooted.
The name under which the Layer 2 Switch startup-config file was uploaded or
downloaded during the most recent TFTP access.
The name of the Layer 2 Switch flash image (system software file) that was
uploaded or downloaded during the most recent TFTP access.
IP Mac
192.168.1.170 0010.5a11.d042
"Displaying global IP configuration information"
on page 884.
"Displaying IP traffic statistics"
Port Age VlanId
7 0
PowerConnect B-Series FCX Configuration Guide
on page 884.
on page 885.
1
53-1002266-01