Dell PowerConnect B-FCXs Configuration Manual page 1169

TABLE 196
This field...
master router <ip-addr> expires
in <time>
track port
Displaying detailed information for an individual VRID
You can display information about the settings configured for a specified VRRP Virtual Router ID
(VRID). For example, to display information about VRID 1.
PowerConnect#show ip vrrp vrid 1
VRID 1
Interface ethernet 3/11
state initialize
administrative-status disabled
mode non-owner(backup)incomplete
priority 12
current priority 12
track-priority 22
hello-interval 1 sec
dead-interval 0 sec
current dead-interval 3.900 sec
preempt-mode true
advertise backup: disabled
Syntax: show ip vrrp vrid <num> [ethernet <num> | ve <num>]
The <num> parameter specifies the VRID.
The ethernet <num> | ve <num> specifies an interface on which the VRID is configured. If you
specify an interface, VRID information is displayed for that interface only. Otherwise, information is
displayed for all the interfaces on which the specified VRID is configured.
This display shows the following information.
TABLE 197
This field...
VRID
Interface
PowerConnect B-Series FCX Configuration Guide
53-1002266-01
CLI display of VRRP or VRRPE detailed information (Continued)
Displays...
The IP address of the Master and the amount of time until the Master dead
interval expires. If the Backup does not receive a Hello message from the
Master by the time the interval expires, either the IP address listed for the
Master will change to the IP address of the new Master, or this Layer 3 Switch
itself will become the Master.
NOTE: This field applies only when this Layer 3 Switch is a Backup.
The interfaces that the VRID interface is tracking. If the link for a tracked
interface goes down, the VRRP or VRRPE priority of the VRID interface is
changed, causing the devices to renegotiate for Master.
NOTE: This field is displayed only if track interfaces are configured for this
VRID.
Output from the show ip vrrp vrid command
Displays...
The specified VRID.
The interface on which VRRP is configured.
Displaying VRRP and VRRPE information
31
1127