•
•
Displaying GVRP configuration information
To display GVRP configuration information, enter a command such as the following.
PowerConnect#show gvrp
GVRP is enabled on the system
GVRP BASE VLAN ID
GVRP MAX Leaveall Timer
GVRP Join Timer
GVRP Leave Timer
GVRP Leave-all Timer
===========================================================================
Configuration that is being used:
block-learning ethe 1/3
block-applicant ethe 2/7 ethe 2/11
enable ethe 1/1 to 1/7 ethe 2/1 ethe 2/7 ethe 2/11
===========================================================================
Spanning Tree: SINGLE SPANNING TREE
Dropped Packets Count: 0
===========================================================================
Number of VLANs in the GVRP Database: 15
Maximum Number of VLANs that can be present: 4095
===========================================================================
Syntax: show gvrp [ethernet <port>]
Specify the <port> variable in the following formats:
•
This display shows the following information.
TABLE 82
This field...
Protocol state
GVRP BASE VLAN ID
GVRP MAX Leaveall Timer
PowerConnect B-Series FCX Configuration Guide
53-1002266-01
CPU utilization statistics
GVRP diagnostic information
PowerConnect B-Series FCX stackable switches – <stack-unit/slotnum/portnum>
CLI display of summary GVRP information
: 4093
: 300000 ms
: 200 ms
: 600 ms
: 10000 ms
Displays...
The state of GVRP. The display shows one of the following:
•
GVRP is disabled on the system
•
GVRP is enabled on the system
The ID of the base VLAN used by GVRP.
The maximum number of ms to which you can set the Leaveall timer.
NOTE: To change the maximum value, refer to
configurable value of the Leaveall timer"
Displaying GVRP information
"Increasing the maximum
on page 510.
14
515